Loader run-in period maintenance and maintenance

After you buy a new wheel loader, the run-in period of the new machine is the key use stage, through proper care and maintenance, you can promote the adaptation of parts, extend life, optimize performance, prevent problems, timely maintenance and maintenance will have a positive impact on the long-term reliability and performance of the loader.

During the run-in period, the various components of the equipment will run in and adapt to each other to achieve the best fit and operating efficiency. Proper maintenance and maintenance can help the parts wear evenly during the run-in period, reduce friction and wear, and thus improve the performance of the equipment. Some potential problems with the device may become apparent. For example, the installation of parts may not be completely tight, the lubrication system may need to be further adjusted, or some parts may require more frequent lubrication. Through regular maintenance and maintenance, these problems can be detected and resolved in time to prevent them from causing more serious failures before the equipment is officially used. Proper maintenance and maintenance can extend the service life of wheel loaders. During the run-in period, the various components of the equipment have not been fully adapted and run-in, so they are more vulnerable to damage or excessive wear. Through timely maintenance and maintenance, the wear and tear of parts can be reduced and their life can be extended, thus reducing the repair and replacement costs of equipment. Wheel loaders typically perform heavy work in the workplace, so safety and reliability are of Paramount importance. During the run-in period, the various systems and components of the equipment need to be fully inspected and adjusted to ensure that they can operate properly and meet the work requirements. Proper maintenance and maintenance can reduce the risk of equipment failure and accidents and ensure workplace safety.

The following is the professional construction machinery manufacturer OXPLO to provide you with 6 points of advice for wheel loaders to pay attention to during the running-in period.

1, the operator should accept the training and guidance of the supplier or specialized agency, have a full understanding of the structure and performance of the wheel loader, before operating the machine, read the "Product use and maintenance manual", and carry out operation and maintenance as required.

2, the working load during the running-in period should not exceed 60% of the rated load, to prevent the machine from overheating caused by continuous operation for a long time.

3, often observe the instrument instructions, abnormal should be stopped in time to eliminate, should stop the operation before the fault is not eliminated.

4, often check the lubricant, hydraulic oil, coolant, brake fluid and fuel level and quality, and pay attention to check the tightness of the whole machine. During the run-in period, the lubrication of each lubrication point should be strengthened, and each shift should be filled with grease for the lubrication point (except for special requirements).

5, keep the machine clean, tighten the loose parts in time to prevent the loose and aggravate the wear or lead to the loss of parts.

6, at the end of the run-in period, the machine should be forced to maintain, do a good job of inspection and adjustment, and pay attention to the replacement of oil.